Notices
EcuFlash

GM 3 port wastegate solenoid not working right

 
Old Oct 18, 2018, 07:13 PM
  #46  
Evolved Member
Thread Starter
iTrader: (1)
 
Lumpy Sticks's Avatar
 
Join Date: Sep 2018
Location: CA/AZ
Posts: 506
Likes: 0
Received 46 Likes on 44 Posts
Too lazy to pop off the DV but it hold vac and boost just fine. Tightened up a few clamps and will test again.
Lumpy Sticks is offline  
Old Oct 18, 2018, 07:23 PM
  #47  
kaj
Evolved Member
iTrader: (58)
 
kaj's Avatar
 
Join Date: Mar 2006
Location: Fresno, CA
Posts: 10,586
Received 322 Likes on 306 Posts
I think you just may have some of these:

kaj is offline  
Old Oct 18, 2018, 09:01 PM
  #48  
Evolved Member
Thread Starter
iTrader: (1)
 
Lumpy Sticks's Avatar
 
Join Date: Sep 2018
Location: CA/AZ
Posts: 506
Likes: 0
Received 46 Likes on 44 Posts
Gremlins for sure. Tested again and same issue. Here is my boost map 1-3 gear. I turned the boost down a hair to see if it helped. It didn't.

Lumpy Sticks is offline  
Old Oct 19, 2018, 03:05 PM
  #49  
Evolved Member
Thread Starter
iTrader: (1)
 
Lumpy Sticks's Avatar
 
Join Date: Sep 2018
Location: CA/AZ
Posts: 506
Likes: 0
Received 46 Likes on 44 Posts
Alright, since I now know this isnt a ecu, tune or solenoid issue, I am going to end the thread and start another one in the right section. Thanks for everyones help up to this point!
Lumpy Sticks is offline  
 


Thread Tools
Search this Thread

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.