Evo9rs will not start after flashing stock map
#1
Newbie
Thread Starter
Evo9rs will not start after flashing stock map
Hi guys,
I own a AUDM 9RS and have been trying to get stock map to run on the car.
Stock ecu was reflashed by previous owner many years ago, now I downloaded 89280002 and 88580015 rom and reflashed it using ecu flash, both roms have the same symptom:
the car cranks and there seems to be spark but will not start. When I revert back to my original (tunes) map, it starts fine.
the car is stock except larger front pipe, titanium exhaust, and aem fuel pump.
any advice would be greatly appreciated!
I own a AUDM 9RS and have been trying to get stock map to run on the car.
Stock ecu was reflashed by previous owner many years ago, now I downloaded 89280002 and 88580015 rom and reflashed it using ecu flash, both roms have the same symptom:
the car cranks and there seems to be spark but will not start. When I revert back to my original (tunes) map, it starts fine.
the car is stock except larger front pipe, titanium exhaust, and aem fuel pump.
any advice would be greatly appreciated!
#2
EvoM Community Team Leader
Immobilizer
#3
Newbie
Thread Starter
Hi Biggie,
Read a bit about that.
I have the code from the original tuned map.
I have tried to edit the new map by putting the immobilized code (hex value in the Immobilizer under ECU section in ECUflash) from old map to the new map, but the value can only be edited in 1% increase or decrease which is very confusing.
Read a bit about that.
I have the code from the original tuned map.
I have tried to edit the new map by putting the immobilized code (hex value in the Immobilizer under ECU section in ECUflash) from old map to the new map, but the value can only be edited in 1% increase or decrease which is very confusing.
Last edited by V9RS; Jul 19, 2019 at 09:43 PM.
#4
EvoM Community Team Leader
Hi Biggie,
Read a bit about that.
I have the code from the original tuned map.
I have tried to edit the new map by putting the immobilized code (hex value in the Immobilizer under ECU section in ECUflash) from old map to the new map, but the value can only be edited in 1% increase or decrease which is very confusing.
For example, original hex is 2001, but the new map has 7B01
Read a bit about that.
I have the code from the original tuned map.
I have tried to edit the new map by putting the immobilized code (hex value in the Immobilizer under ECU section in ECUflash) from old map to the new map, but the value can only be edited in 1% increase or decrease which is very confusing.
For example, original hex is 2001, but the new map has 7B01
to change it in hex start it off with a "0x" so 0x2001
The following users liked this post:
RevMaynard (Jul 25, 2019)
#7
EvoM Community Team Leader
Your welcome I'm glad it all worked out.
The following users liked this post:
RevMaynard (Jul 25, 2019)