TariqEvo

My car is basically a stock evo 03 with a 9 turbo, and a perrin 3 inch full exhaust system.
redline AFRs go all the way to 10.4, doing 23psi as of now till i replace my actuator and tune for 25psi
why are my load figures this high? is it normal? attached is my current rom and the newest log.

Project_Broke

iTrader: (2)

That load is all messed up.

Can you try logging 1byte w/tephra? Hell, even Loadcalc may be more accurate.

Also, that's pretty rich up top.

TariqEvo

About the richness, I will tune it properly after addressing the issue,
but thing is, if the load readings were not accurate, why am i able to get rid of knock at those high loads on the table, I even rescaled the tables to accomodate that much load.

Project_Broke

iTrader: (2)

MAF Scaling way off maybe?

I'm not at a computer with access to look at the tune. But no way in hell should you hit that much load with that much boost.

Project_Broke

iTrader: (2)

Also, post this in the ecuflash section. You'll get better advice.

TariqEvo

Dakota Evo

is your load set up correctly on evoscan

maybe your factor is 1.8 or 2.0

have to see your rom and evoscan to determine this

Dakota Evo

saw your rom

i would prob switch over to tephra and disable lean spool to get more consistant tune....and you might have a boost leak

TariqEvo

no boost leak at all, and i have not messed with evoscan definitions, mut 2byte load is defined correctly. the maf is really sending out those readings, could it be an issue with the maf sensor itself?

2winscroll

2winscroll