320/302 on STM's Mustang Dyno
 

http://i32.photobucket.com/albums/d2...aph008edit.jpg


http://i32.photobucket.com/albums/d2...ti/Dyno021.jpg


A big note of thanks to everyone at STM for putting up with me for the last 3 years. The car runs really well. Its drivability is superb and it feels like there's power everywhere.

http://i32.photobucket.com/albums/d2.../Inside024.jpg


We were very happy with the result, considering the car is close to stock. The power mods are minimal: TBE w/HFC, MBC @ 24PSI, drop-in filter, and a Buschur FMIC. Everything else is factory.

Very nice for minimal mods

not bad at all. especially when you get real numbers! congrats

Thanks, guys. I should mention that the car runs on 93. STM's Mustang reads very low. Seeing what fully modded Evos run on this MD, I expected to see somewhere around 280whp. Em thought we'd see about 300. We were all very surprised by the final numbers. It's possible that a reduction in rotational mass - ~30lbs less than stock - was in part responsible for what we saw. I've been told that a stock 400hp Viper puts down ~280whp on this dyno.

Felix, I'm am glad to have you as a customer and friend! Good to see you finally have your car running to its potential!



Have fun with it

-Em