![]() |
Joe's Evo IX Stock block MAP EF3 93oct & E60
I had the pleasure to tune Joe's low mileage Evo IX. Joe wanted a few things
changed before tuning, and I recommended a few other things as well. The vehicle was very fun to tune and drove excellent. As good or better then a bone stock evo. We performed the following on the car: 1. Installed a TSComptuned Walbro 255 /w modification and install kit 2. Cleaned engine bay, added vacuum lines where they were missing, and visually inspected the entire car. 3. Added a Grimmspeed 3 port to the vehicle in combination with the existing Hallman Pro 4. Crimped dipstick / added more oil since the vehicle was down over a full quart. 5. Installed fresh spark plugs 1 step colder and gapped accordingly 6. Tuned vehicle on a dual map Tephra v7 Mods of the vehicle are as follows: Stock block /w 39K miles 3.5" ETS fmic /short route piping Tial 50mm bov Milspec TB REV3 Intake manifold FIC 1250cc inj TSComp Walbro 255 /w mod GSC S2 cams Ported exhaust manifold MAP EF3 Turbo /w Turbosmart 18psi WGA Invidia o2 housing / Invidia DP STM aluminum exhaust /w hfc Grimmspeed 3 port + Hallman Pro (Hybrid) Tephra v7 SD /w hybrid boost The car I had put over 520whp on the E60 blend but I didnt like the AFR curve, as it was showing signs of pump not being able to keep up, so I dialed it back quite a bit. This can be shown by the yellow graph The car was an absolute blast to tune on the street. The EF3 is a really nice responsive turbo and this cars mods just worked together so well. 93 oct results & E60 together: (Blue line: Final tune | Yellow line: Pump maxed | Green line: Ok, but dialed it back just a tad from there) https://cimg3.ibsrv.net/gimg/www.evo...d1fe378f3e.jpg Some pictures of the vehicle: https://cimg5.ibsrv.net/gimg/www.evo...d65cbfc7ba.jpg https://cimg6.ibsrv.net/gimg/www.evo...425cb288d5.jpg https://cimg7.ibsrv.net/gimg/www.evo...8b7c3b7ce2.jpg |
Nice numbers Tom and a beautifully, well kept car.
|
Nice..I have a similar setup but with AEM EMS...Thinking about going back stock ECU to run tephra SD V7
|
Very clean!
|
| All times are GMT -7. The time now is 03:16 PM. |
© 2026 MH Sub I, LLC dba Internet Brands