Notices
Evo Engine / Turbo / Drivetrain Everything from engine management to the best clutch and flywheel.

Big Problems???

Thread Tools
 
Search this Thread
 
Old Dec 26, 2004 | 07:35 PM
  #16  
BSREVOLUTION's Avatar
Thread Starter
Evolved Member
iTrader: (15)
 
Joined: Feb 2004
Posts: 512
Likes: 0
From: Bakersfield, CA
Reply
Old Dec 26, 2004 | 08:23 PM
  #17  
SuperchargedGTZ's Avatar
Evolved Member
iTrader: (4)
 
Joined: Feb 2003
Posts: 946
Likes: 0
From: Gilbert, AZ
when i did a compression test a while back, because i freaked out when i blew my oil stick out, i had 165 across the board

i guess if they are just all consistent than it is all good
Reply
Old Dec 26, 2004 | 08:31 PM
  #18  
Jakeg97's Avatar
Evolved Member
iTrader: (56)
 
Joined: Sep 2004
Posts: 11,132
Likes: 1
From: Western NY
Originally Posted by BSREVOLUTION
im thinking my gf kicked thw switch last night while we were driving. .
how did that happen
Reply
Old Dec 26, 2004 | 08:35 PM
  #19  
nothere's Avatar
Evolved Member
iTrader: (23)
 
Joined: Jan 2004
Posts: 2,680
Likes: 1
From: Bellevue. WA
is this where the thread goes NWS
Reply
Old Dec 26, 2004 | 08:47 PM
  #20  
Quickshift's Avatar
Evolved Member
iTrader: (4)
 
Joined: Aug 2003
Posts: 1,189
Likes: 0
From: MD
Your compression will vary depending if the engine was just run and that there is a good amount of oil still on the rings, which in turn will give you a higher reading. But if the car had been sitting a while (ei. cold engine) then was just tested then a lower reading would show up. But the fact that it is consistent across the engine it is good
Reply
Old Dec 26, 2004 | 08:51 PM
  #21  
DynoFlash's Avatar
Account Disabled
iTrader: (91)
 
Joined: Sep 2003
Posts: 16,850
Likes: 0
From: 2003 Evo VIII - Silver
try the compression hot - generally if they are all even you are cool
Reply
Old Dec 27, 2004 | 09:33 AM
  #22  
BSREVOLUTION's Avatar
Thread Starter
Evolved Member
iTrader: (15)
 
Joined: Feb 2004
Posts: 512
Likes: 0
From: Bakersfield, CA
cool, yeah the car was sitting for about 4hours before the test. and the switch was kicked because i haven't found a place to mount it yet. im going to see if it fits in the ic spray button position.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
moyassine
Evo General
6
Feb 21, 2016 10:54 AM
Indianbrandon
Evo X Engine Management / Tuning Forums
3
Dec 28, 2012 01:20 AM
mikeymisfit
Lancer Troubleshooting
25
Mar 7, 2007 06:29 PM
FeRRarI eAtR714
Evo Engine / Turbo / Drivetrain
25
Dec 20, 2005 10:34 PM
TrskitEvo8
Evo Engine / Turbo / Drivetrain
16
Jun 23, 2004 06:14 AM




All times are GMT -7. The time now is 05:15 PM.