I'm installing a 20GLT. The banjo bolts for the coolant & oil lines have holes on each side of the bolts. Do I have to mark and note to orientation of the holes to match the coolant/oil lines? I just want to make sure if there was a preference. Let me know what you guys have done with them.

 

It goes the same way as stock. They only go one way.

 

i meant the direction of the 2 holes that go through the banjo bolts. Do they have to be facing the lines?

 

No. The orientation of the holes do not matter.

 

can you reuse all of the gaskets, I think there brass right?

 

No, do not reuse the gaskets. Get new copper crush washers and a new gasket(s) for the oil drain tube.