Soooooo I'm laid up after surgery with exposed pins in both feet... anyone want to PM/email me as to the results of the FP4's? I can't drive, nor ride any of my bikes for 4-6 weeks. Unless someone loves me, it's not like I can run down and pick up the rag.


Thanks for the PMs guys

 

AMS guys,

Any chance to see the torque graphs for the better cams?

 

I just buy the new Turbo mag an theres the FP4 review.
At 22psi this cams make 465whp with almost similar stock spool up and better top end than HKS 272.

 

deleted

 

nice, hopefully thats what the s2's do as well asi just bought some

 

Martin, can you tell us what cam gear adjustments were needed to get each cam to the spec of the manufacturer?

 

nah we did better than that

 

Hi Greg would love to see what you've found.

I know when we degreed my friends Revolvers, we had to go 11 CAM degrees over to make up the over 20 crank degrees the intake cam was off.

 

where is the next graph?

 

BOOYAH!!

 

Martin is out of town right now but we are going to do our best to get an update up here tomorrow.

Eric

 

nice work

 

Any luck on seeing some Cosworth M1 or M2 cam results?

 

Cosworth wasn't in the test.

 

Gotcha....but that doesn't mean that they CAN'T be tested.....hopefully one day

With the Evo VIII Cosworth M2's (which have a 280 duration and an 11.0mm lift on both cams) the results should be pretty good in comparison since similar cams are used by most Evo IX owners....lets get the VIII owners some similar 'dyno proven' results

Evo VIII Cosworth M2 Spec sheet...

http://www.cosworth.com/uploads/1147891526.pdf