ya on evo setup shimming wouldnt do any good now that i see how the actuator is connected. what you did is the only solution for the evo setup

 

ah ok good.

 

 

I want to spike 31 and hold atleast 28 till 7k. I'll spike 30 and instantly it drops and drops to 25.4 to 25.8 and I lose so much power

 

You might be able to do that. you have ecu controlled boost? If not you should invest into the AEM boost solenoid. Also it may be your tune or a boost leak that will make you lose boost up top.

 

mods in sig with 950's going in. =)

 

I have a HKS EBC, I don't think I have a leak but I might.

 

Hi what power can i make with my setup?
Its daily drive.

2.4 4g64 engine
FP red 80mm
ETS 3.5 FMIC
Walbro 255l
Pipercams and pullis
Autronic ecu
AVC-R boostcontroler
Snowperformance Methkit mix 50/50 water
3" Exaust

Thanks

 

550ish but run 100% meth. Don't cut yourself short

 

its engine power 550?
I hope 400 ; 420 awhp.
But 100% meth its a daily car will it be ok?

 

^It should be fine - I just make sure to get the pump flowing when driven (don't let the meth sit, basically). I think of a meth setup kind of like a hot tub - the worst thing that you can do is *not* use it.

btw - you should easily clear 420 to the wheels, unless you are on some low reading mustang.

 

Around here its superflow dyno.
And not so high hp but high tq now running 380 hp and 650tq.
Hope to get som nice power from the red with a good tune :-)
Thanks for the reply

 

No 500-550 to the wheels is reasonable for a Red. Yes 100% meth is daily driven. remember you are only injecting meth over say 12lbs of boost. under that and normal throttle you are running normal gas like 93 or 92 whatever you may have in your area

 

Yahu, don't lie jk... I'm at 420 on stock turbo. Red with the right combos can make way into the 500s

 

You guys are seeing 500 plus whp on a red?? I'm at like 380 or 390 with 100% meth. . Its is a low reading mustang dyno but damn yall are making way more.