Stock Rods w/arp hardware?
Thread Starter
Evolving Member
iTrader: (7)
Joined: Dec 2005
Posts: 240
Likes: 0
From: Jeanette near Pittsburgh
Stock Rods w/arp hardware?
I need to do a pan gasket on my car, and was contemplating putting some ARP rod bolts along with some new bottom end bearings in the car. The car has 70k miles on it, and i figured it couldnt hurt.
The car is fairly simple, and probly will never see over 400hp so i dont plan on going to a full forged set up....but am i wasting my money with the upgraded hardware & bearings?
The car is fairly simple, and probly will never see over 400hp so i dont plan on going to a full forged set up....but am i wasting my money with the upgraded hardware & bearings?
Yeah i wouldn't waste my time with it either. If i remember right, i think you have to press the stock ones out anyways. Good luck.
Aaron
Aaron
Last edited by WHTEVO; Feb 26, 2009 at 07:35 PM.