Cat-Delete 02 Sensor
#1
Newbie
Thread Starter
Cat-Delete 02 Sensor
Looking at getting a de-cat for my evo 8, I currently have a high flow cat and an 02 sensor already before the cat hooked up to a AFR Gauge, now im wondering with the new de-cat test pipe this has a 02 sensor hole in it already as seen in the picture below. would I get a CEL light if i just capped it off with a threaded bolt.
[img]data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAE AAAICTAEAOw==[/img][img]data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAE AAAICTAEAOw==[/img]
[img]data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAE AAAICTAEAOw==[/img][img]data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAE AAAICTAEAOw==[/img]
#2
EvoM Staff Alumni
iTrader: (3)
Looking at getting a de-cat for my evo 8, I currently have a high flow cat and an 02 sensor already before the cat hooked up to a AFR Gauge, now im wondering with the new de-cat test pipe this has a 02 sensor hole in it already as seen in the picture below. would I get a CEL light if i just capped it off with a threaded bolt.
One thing that comes to mind is that the engine tune is likely setup w/the HF CAT & removing the CAT will change your exhaust flow. Consider a re-tune?
#3
EvoM Community Team Leader
If you had already deleted the downstream narrowband 02 sensor, then you will be fine.
Like MinusPrevious said, you will need to tune for a test pipe.
Like MinusPrevious said, you will need to tune for a test pipe.
#4
EvoM Guru
iTrader: (1)
Not today EPA.
Thread
Thread Starter
Forum
Replies
Last Post
Evolution8Blue
General Engine Management / Tuning Forum
9
Jun 6, 2006 08:52 PM