Hey guys, some help would be appreciated. I searched and read threads about fitment but I think I have everything installed correctly. The test pipe was labeled "Bottom ----> Flow" I have the writing facing the ground and the flow going towards the muffler. My muffler is hanging to the passenger side really bad, I have the hanger pulled towards the drivers side otherwise it would be even closer to the passenger side. Also in one of the pictures I have a red circle, is this the heat shield people removed?

 

Bump

 

Post up the pics in the AMS section they are usually pretty good at helping people out

 

Is it supposed to be an angled exit? That's what it kind of looks like.

 

This customer has contacted us through email and we are working with him to get all of this sorted out asap

 

Yup Andrew has bees helpful going to rotate test pipe.

 

What about the heat shield? I know you said it doesn't need to be removed but right now it's resting on the bolt. I guess with the rotation of the test pipe it might move it back off the heat shield?

 

The exhaust should back off the heat shield a bit but we always remove this bracket when installing turbo back exhausts here to make sure that there is no contact when driving.

 

Rotated the test pipe with the "Bottom---->Flow" facing the car and the exhaust now sits in the middle perfectly. Just an FYI to anyone that gets the AMS I could check how the flanges meet up before installing even if it's labeled bottom it may not be correct.

 

Glad you got it sorted out! AMS is made well--- quality product.