After getting my turbo back and installing the Megan O2 housing I wanted to bolt up the DP and move my "project" a little further along. When I pulled out the "doughnut" gasket I ordered (the stock replacement one) it seems that its way to small to fit on the new O2 housing. Sure enough, when I tried to mount it all up it IS waaay to small...lol My question is, has anyone else run across this and if so what have you guys used to fix the issue? I'm thinking that the O2 housing may have come with one but when I sent the turbo/housing/manifold out to be "cleaned up" it may hove gotten "misplaced" Any help you guys could give would be appreciated. Thanks in advance.

 

The Megan o2 housing uses the OEM doughnut gasket. I had re-used my original one off the factory o2 housing. They are a pretty tight fit, so trying playing with it.

 

Hmm..Ok i'll give it a shot. I'll run to Mitsu. tomorrow and grab one. Thanks.

 

How did the Megan outlet work out? I'm on the verge of ordering one. Anyone else with good or bad experience with this piece?