ConnorEvoIXMR

Hey,

Does anyone have any recommendations on an intake pipe and a different lower rad hose that doesn't rub on the slave cylinder boot? The intake is kind of pressing on the lower rad hose but when I lift the intake up the lower rad hose is still pressed pretty hard against the slave cylinder boot. it was pressing hard enough on it earlier that it only let the clutch pedal come up half way for a few seconds until i pulled it back up with my toe.

Please and Thank you for the replies!

-Connor

240Z TwinTurbo

iTrader: (25)

Stock hose shouldn't hit the slave unless something was modified. You can always route the coolant hose custom like I did to free up some room.

ViciousLSD

iTrader: (2)

are you sure its not backwards/upside down? i bought an ebay silicon hose set and it fits fine