Re-Install BS
#1
Re-Install BS
Its been a while....I am pulling my motor after a while of daily driving and neglect due to life.
I need to find any good information on reinstalling my Balance Shafts. I have had them out for a couple of years, and only really have an odd low oil pressure problem at idle. However, I am going to less peak power and looking for better powerband, and will be changing a few things and thought based on the latest info I should probaby put them back in.
Can anyone give any advice if you have installed the BS's. I remember removing them and reinstalling the bearings was a PITA, even on an engine stand. I suspect installing new bearings perfectly will be even more tricky.
I didn't see any posts or a how to in installing the balance shafts and the bearings. Any info appreciated!
Mike
I need to find any good information on reinstalling my Balance Shafts. I have had them out for a couple of years, and only really have an odd low oil pressure problem at idle. However, I am going to less peak power and looking for better powerband, and will be changing a few things and thought based on the latest info I should probaby put them back in.
Can anyone give any advice if you have installed the BS's. I remember removing them and reinstalling the bearings was a PITA, even on an engine stand. I suspect installing new bearings perfectly will be even more tricky.
I didn't see any posts or a how to in installing the balance shafts and the bearings. Any info appreciated!
Mike
Thread
Thread Starter
Forum
Replies
Last Post
madpacket
Evo Engine / Turbo / Drivetrain
2
Sep 30, 2005 11:38 AM
GOKOU
Evo Engine / Turbo / Drivetrain
23
Aug 19, 2005 04:51 PM
platinumspecv
Turbotrix Racing - Edison, NJ
3
May 22, 2005 11:16 AM
bacardioplaya
Lancer Audio and Security (All models)
3
Jun 20, 2004 02:28 AM