ATS triple metal plate
#1
Newbie
Thread Starter
ATS triple metal plate - noise
So my pull type twin plate metal gave way and gotten a push type triple plate metal. The pedal is much harder than the twin but grips alot more. Every engagement was crisp and smooth and ran in for about 300miles.
I noticed after downshift on high rev while the clutch pedal still half depressed, theres a slight rubbing noise till i fully let go of the clutch. This happens only on high rev irrespective of gears and totally no sound of low or normal rev e.g 1000 - 3000rpm.
Should it be a cause of concern?
I noticed after downshift on high rev while the clutch pedal still half depressed, theres a slight rubbing noise till i fully let go of the clutch. This happens only on high rev irrespective of gears and totally no sound of low or normal rev e.g 1000 - 3000rpm.
Should it be a cause of concern?
Last edited by inin36; Nov 11, 2018 at 06:34 PM.
#2
Newbie
Thread Starter
I searched the entire forum and found out it is normal. but mine was new and the noise came right away after i install it.
anyone?
anyone?
Last edited by inin36; Nov 15, 2018 at 06:35 PM.