Installed my rally shift indicator
Thread Starter
Evolved Member
iTrader: (38)
Joined: Nov 2006
Posts: 1,745
Likes: 10
From: New Hampshire, USA
Installed my rally shift indicator
I don't think I've seen anyone on EvoM that has this, but it's a nifty little device I ordered from Australia...
7 lights, multiple modes. You just wire up power, ground, and tach... set the "low" RPM and the "high" RPM (set with buttons, no need to rev the engine).
Made by www.ecliptech.com.au
Video: http://www.youtube.com/watch?v=XNlV514h0NI

7 lights, multiple modes. You just wire up power, ground, and tach... set the "low" RPM and the "high" RPM (set with buttons, no need to rev the engine).
Made by www.ecliptech.com.au
Video: http://www.youtube.com/watch?v=XNlV514h0NI
Thread Starter
Evolved Member
iTrader: (38)
Joined: Nov 2006
Posts: 1,745
Likes: 10
From: New Hampshire, USA
I believe it was $180 shipped. The install was cake... just tapped the tach signal on the ECU and I had a spare power/ground already run for a gauge I used to have, so I was done in 15 minutes.
I want to make a nicer mount instead of ugly velcro, but I was anxious to take the video :-)
I want to make a nicer mount instead of ugly velcro, but I was anxious to take the video :-)




