Intermediate shaft stuck in t-case
#3
Evolved Member
iTrader: (41)
What is your slide hammer method? It seems to always work for me so perhaps there is something silly that is limiting you? Also, may I ask why you are removing it? The xcase can be pulled with that one still installed so perhaps you dont even need to remove it just yet?
#5
EvoM Guru
iTrader: (1)
The wave trace are a super tight fit. You have to really get after it with the slide hammer.
#7
Evolved Member
iTrader: (41)
Lol make sure to setup the camera before doing that! I still think a good solid whack with the slide hammer should do the trick. Are you using the hook thingies to grab the bolt head? One cool trick I was told was use the attachment for the 2 jaw puller and just slip the bolt head inside that if that makes sense.
The other trick you could do is use a bolt, nut and a spacer. Thread bolt into the half shaft then turn the nut which will move that inward untill it pressed up against the spacer and acts a a means to pull the entire shaft out. Not sure I explained that well but think about it and hopefully it'll make sense.
The other trick you could do is use a bolt, nut and a spacer. Thread bolt into the half shaft then turn the nut which will move that inward untill it pressed up against the spacer and acts a a means to pull the entire shaft out. Not sure I explained that well but think about it and hopefully it'll make sense.
Trending Topics
The following users liked this post:
DontStopMe (Jun 2, 2020)
Thread
Thread Starter
Forum
Replies
Last Post
BuiltS13
Evo Engine / Turbo / Drivetrain
15
Jan 23, 2011 10:15 PM
BuiltS13
Northwest Region
8
Jan 23, 2011 02:19 AM
Xearo
Evo Engine / Turbo / Drivetrain
1
Jan 15, 2011 09:17 AM
ryanlao
Evo Engine / Turbo / Drivetrain
7
Oct 30, 2008 01:00 PM