Grandpa Evo's timeline with parts list...
#1
Grandpa Evo's timeline with parts list...
This is a list of stuff: I had a previous post but it is way too old now,LOL.
For informational use(especially newbies who think its cheap to maintain evo's):
Oil/Filter changed every 3k-5K.
64K- got that car used. It had DP,Intake,MBC.
65K- Did a Full Timing belt service with WP. Installed BOV, Fuel pump, Turbo Timer, and Brake guides.
80K - Brakes- Installed Brake Guides. Rotors and Pads changed due to warping and being worn. I lived with the warped rotors until I needed to change the pads.
85K- New silicone wipers
91K- Installed new headlight indicator bulb(blew out)
115K- Replaced both front wheel bearings due to noise
120K- Another Timing belt service with WP. Changed Spark plug wires too, just because.
140K- Vortex generator and headlight eyebrows added
155K- Installed Pioneer AVIC head unit. Needed an IPOD with all of the driving.
166K- Installed Oil pressure sender, original one kept causing oil light to come on. Pressure was okay. Brakes and Rotors again.
173K- Installed HVAC display bulbs(one blew out) also another headlight indicator bulb.
181K- Timing belt service again with WP
183K- Installed HVAC Gear kit (hard to turn)
185K- Installed Greddy Full Titanium Cat back and Kelfords installed
186K- Amsoil fluids
197K- Installed AMS LICP
204K- 100 cell Mil.Spec cat installed
207K- ETS FMIC,AEM WB,Brakes and Rotors
208K- Boost gauge
209K- Engine rebuild with Wiseco pistons,eagle rods,ARP main/head studs,Cosworth bearings(belts etc.) Clutch(HDSS with ACT flywheel)
216K- Ported BBK-Full,Titek O2,and ported ex mani
219K- Car accident! New Hood+ extra carbon hood,Front Bumper,RF Fender,and Headlight housings
230K- Bilsteins,parking brake shoes,Brakes and Rotors
255K- Left front hub/wheel bearing
260K- Aeromotive 340 FP
267K- Mishimoto Radiator and hoses,New set of injectors(just because),Headlight bulbs,marker bulbs
268K- Rear lic plate mount with bulb housings(rusted out)
270K- Redline MT-90 in trans, Diaqueen TC and Rear
273K- CBRD BBK-3B turbo and Powdercoated BBS with Dunlop Star specs
Car still has original trans, transfercase and rear diff
Original clutch lasted till 209K when I ripped the engine out, figured might as well change it,LOL
http://www.flickr.com/photos/57648191@N03/6857430596/http://www.flickr.com/photos/57648191@N03/7003545241/http://www.flickr.com/photos/57648191@N03/6857430562/
I want to thank these guys for all the help in keeping this car moving:
Jestr Tuning
CBRD
ETS
MAPerformance
No Limit Motorsports
STM
Buschur racing
Mitsubishiparts.net
Paramus Mitsubishi
For informational use(especially newbies who think its cheap to maintain evo's):
Oil/Filter changed every 3k-5K.
64K- got that car used. It had DP,Intake,MBC.
65K- Did a Full Timing belt service with WP. Installed BOV, Fuel pump, Turbo Timer, and Brake guides.
80K - Brakes- Installed Brake Guides. Rotors and Pads changed due to warping and being worn. I lived with the warped rotors until I needed to change the pads.
85K- New silicone wipers
91K- Installed new headlight indicator bulb(blew out)
115K- Replaced both front wheel bearings due to noise
120K- Another Timing belt service with WP. Changed Spark plug wires too, just because.
140K- Vortex generator and headlight eyebrows added
155K- Installed Pioneer AVIC head unit. Needed an IPOD with all of the driving.
166K- Installed Oil pressure sender, original one kept causing oil light to come on. Pressure was okay. Brakes and Rotors again.
173K- Installed HVAC display bulbs(one blew out) also another headlight indicator bulb.
181K- Timing belt service again with WP
183K- Installed HVAC Gear kit (hard to turn)
185K- Installed Greddy Full Titanium Cat back and Kelfords installed
186K- Amsoil fluids
197K- Installed AMS LICP
204K- 100 cell Mil.Spec cat installed
207K- ETS FMIC,AEM WB,Brakes and Rotors
208K- Boost gauge
209K- Engine rebuild with Wiseco pistons,eagle rods,ARP main/head studs,Cosworth bearings(belts etc.) Clutch(HDSS with ACT flywheel)
216K- Ported BBK-Full,Titek O2,and ported ex mani
219K- Car accident! New Hood+ extra carbon hood,Front Bumper,RF Fender,and Headlight housings
230K- Bilsteins,parking brake shoes,Brakes and Rotors
255K- Left front hub/wheel bearing
260K- Aeromotive 340 FP
267K- Mishimoto Radiator and hoses,New set of injectors(just because),Headlight bulbs,marker bulbs
268K- Rear lic plate mount with bulb housings(rusted out)
270K- Redline MT-90 in trans, Diaqueen TC and Rear
273K- CBRD BBK-3B turbo and Powdercoated BBS with Dunlop Star specs
Car still has original trans, transfercase and rear diff
Original clutch lasted till 209K when I ripped the engine out, figured might as well change it,LOL
http://www.flickr.com/photos/57648191@N03/6857430596/http://www.flickr.com/photos/57648191@N03/7003545241/http://www.flickr.com/photos/57648191@N03/6857430562/
I want to thank these guys for all the help in keeping this car moving:
Jestr Tuning
CBRD
ETS
MAPerformance
No Limit Motorsports
STM
Buschur racing
Mitsubishiparts.net
Paramus Mitsubishi
Last edited by 4RETECH; Mar 21, 2012 at 11:27 AM.
#6
Evolving Member
Join Date: Jul 2006
Location: sacramento
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
Damn, I am at 90k purchased August 06 and I still don't have any major mods. Just a drop in panel filter, basic tune and Swift springs. I do all of my maintenance on time and switched to redline ****tail and used diaqueen from the get go. I recently switched to Amsoil.
My car should be able to go the distance like yours. I only auto-x once or twice a year and it is my DD, maybe i'll join your 200k club in a few years.
My car should be able to go the distance like yours. I only auto-x once or twice a year and it is my DD, maybe i'll join your 200k club in a few years.
Last edited by evo milk; Mar 20, 2012 at 11:20 AM.
Trending Topics
#12
Evolving Member
iTrader: (8)
Join Date: Jun 2011
Location: Lansing, MI
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
Very helpful! I was curious of some ballpark estimates of when I will need to change some things out. Just joined the 100k club a couple months ago!
Also, I have to say it is quite amazing to see the clutch lasting that long... Even more impressive with the mods you are running.
Also, I have to say it is quite amazing to see the clutch lasting that long... Even more impressive with the mods you are running.
#13
I actually have a SHEP 5 spd trans in the box (just incase)
But TC is still fine, prob gonna get a SHEP one sooner or later (just incase)
And thanks everyone.
Chad, you should be getting the BBK-Full tomorrow for the 60K inspection.
#14
Newbie
iTrader: (2)
Join Date: Nov 2009
Location: Santa Cruz/Santa Barbara
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Sounds like the car was well-driven in near stock condition for a while before the real mods hit! My clutch is starting to slip at 38k but its been on 450whp for most of its life Thanks for sharing dude! Encouraging to see how long this car can last when taken care of properly!