Ok have all the supporting mods listed below

25g turbo
Ported manifold
70mm throttle body
272 cams
1200cc pte injectors
3" exhaust + cut out
2.5" map licp
3.5" intercooler
Short route nisei uicp
450lph fuel pump "e85 only"

Issues
Clutch changing next week
Evo 9 bov - need 30+ psi maybe
Wastegate - looking at forge maybe to put me at 30psi

Which bov is a must to hold the boost that will work with my uicp? Trying not spend too much money just dropped $1400 last week.

Currently researching on the 25g for whp and psi

 

Ive tried this turbo they are pretty damn good if you get the 10.5 hotside.

There is a mod the bov with out crushing it that will hold 34 PSI on the 9 BOV.

We used a crush one in the set up we ran because it hasnt seen more than 28 PSI.

 

Tial Q BOV

 

Might as well. Won't have to worry about holding the boost with a TiAL and good to have piece of mind.