I have installed it twice and and now i am going to ask every one here.I have thrown the CEL light, with the simulator installed. i know it sound stupid but how come it doesnt work.

i have taken the wire that is grounded and grounded it to the body. because that was the problem before. is the simulator light suppose to blink or is it suppose to be solid.

i am alittle agrivated with this situation. any help would be greatly appreciated because that " SERVICE ENGINE SOON" Light is damn ugly.

for anyone who has the Perrin O2 simulator have you had problems, if so what were they, and how did you fix it, if not what am i doing wrong, I did it exhastly how it was said to do.

 

All the forum members and not a single response? Come on i know people have ran into problems before. just help a fellow EVO owner out.

 

This forum doesn't get a LOT of attention/readers, but someone will eventually respond so sit tight. You may have better luck contacting Perrin anyhow.

 

Last time I heard from Perrin is that they are back on the drawing board because some O2 simulators aren't quite working like they're suppose to. I'm still waiting...

 

It took them 3 tries to get mine correct, but now no problems. Call Perrin directly...they are very helpful and knowlegeable. I have the number around here somewhere...

Peter

 

did you get it to work now? mine is doing the same thing. hit me back THANKS

 

Damn, still no fix? anyone figure out yet?