DIY:How to Install Universal (bosch) o2 sensor
#31
Evolved Member
iTrader: (26)
Hope this helps
As I stated above ...^ , I used a new universal sensor off a Montero. Because both are of four wire type and are identical to spec US VIII-IX's sensors.
REAR O2
WIRES COMING OUT OF CAR UNIVERSAL WIRE BOUGHT FROM STORE
BLACK---------------------------------><--------------------------BLACK
BLUE/STRIPE-------------------------><--------------------------WHITE
WHITE---------------------------------><--------------------------GRAY
RED/YELLOW--------------------------><------------------------WHITE
"---><--- " :means wires are spliced and connected.
I choose to cut the connector(female) coming from the car,not really neccesary,but I felt it was easy for me. I haven't had any electrical issues and passed emissions withflying colors. Please when working around electrical items make sure battery is disconnected.
REAR O2
WIRES COMING OUT OF CAR UNIVERSAL WIRE BOUGHT FROM STORE
BLACK---------------------------------><--------------------------BLACK
BLUE/STRIPE-------------------------><--------------------------WHITE
WHITE---------------------------------><--------------------------GRAY
RED/YELLOW--------------------------><------------------------WHITE
"---><--- " :means wires are spliced and connected.
I choose to cut the connector(female) coming from the car,not really neccesary,but I felt it was easy for me. I haven't had any electrical issues and passed emissions withflying colors. Please when working around electrical items make sure battery is disconnected.
Last edited by Sil'vr-Boi6; Sep 14, 2010 at 06:58 PM.
#39
Help evo 8 o2 conector with an evo 9 o2 sensor
hello dear Evo friends
i have a 2003 evo 8 my problem is i have for the rear o2 i have a white flat connector but i have 3 o2 sensors but this are for later evo 8 and 9 this have the grey square connector so i wanted to splice mine and use the one i have my car has 4 colors the o2 sensor i have doesnt have the same color please help me out
i have a 2003 evo 8 my problem is i have for the rear o2 i have a white flat connector but i have 3 o2 sensors but this are for later evo 8 and 9 this have the grey square connector so i wanted to splice mine and use the one i have my car has 4 colors the o2 sensor i have doesnt have the same color please help me out
#40
Evolving Member
While the information in this thread is extremely informative, I couldn't really find information describing the engine side of the harness and breaking it down. So I made a quick thing in excel to help me figure out where to wire a universal one straight into the oem harness.
Please correct me if this information is wrong, but I tested it to be correct on my 03 USDM Evo for the FRONT O2 sensor.
Please correct me if this information is wrong, but I tested it to be correct on my 03 USDM Evo for the FRONT O2 sensor.
#43
You can get a new connector and crimp it on.
Available here.
https://sites.google.com/site/mister.../4p-connectors
Available here.
https://sites.google.com/site/mister.../4p-connectors
Thread
Thread Starter
Forum
Replies
Last Post
mrwickd123
Evo X How Tos / Installations
30
Feb 20, 2019 09:29 PM
ShiftyPenguin
Evo How To Requests / Questions / Tips
9
Nov 12, 2016 05:01 AM
mrwickd123
Evo X How Tos / Installations
11
Nov 2, 2016 10:19 PM