bvliz

iTrader: (20)

I know there has been a million posts on this subject sorry,I have read all different ways to test the sensor,Do you use volts or ohms to test it,I have 3 sensors that read 0 on volts,2 are brand new,one is oem,but read ohms just fine.thank you

BrownParticles

I wonder too. I've read they you're supposed to use either EvoScan or ECUFlash to set it to 13% or so at rest. I'm not sure which program I need though.

Teal2nnr

iTrader: (7)

0.535 − 0.735 V. So under a volt if your multimeter reads that low. Or use millivotls.

bvliz

iTrader: (20)

Thanks guys for the response,I figured it out,plus I had a bad Omni 4 bar map sensor