EvolutionM - Mitsubishi Lancer and Lancer Evolution Community

EvolutionM - Mitsubishi Lancer and Lancer Evolution Community (https://www.evolutionm.net/forums/)
-   Evo How Tos / Installations (https://www.evolutionm.net/forums/evo-how-tos-installations-82/)
-   -   How to video: fixing stuck heater control knob (https://www.evolutionm.net/forums/evo-how-tos-installations/582010-how-video-fixing-stuck-heater-control-knob.html)

DontStopMe Nov 2, 2011 08:08 PM

Booste Films video How to: fixing stuck heater control knob
 
HVAC repair. Installing revised gears and a new control cable.
http://www.youtube.com/watch?v=vcG20LmRZFU

More evo how to videos here:
http://boostedfilms.com/joomla/videos/how-to-videos-car

vmrevo9 Nov 2, 2011 08:16 PM

subscribed! thanks for the vid

GaBe511 Nov 2, 2011 08:33 PM

Great Vid again! Wish my fix was that easy, but the gears didn't help, so the blend door is to blame.

Piro Fyre Nov 2, 2011 09:07 PM

Man, you sure like weight savings. :D

Luckily, I didn't have to go through all that and just had to do the gears. Was really easy to do.

sujinX Nov 3, 2011 12:47 AM

very nice!
found it. heres the part numbers
Part # Description
MR979515 Wire+heater Contr
7801A110 Link+heater Air C

jr-mack Nov 8, 2011 06:56 PM

nice video. my heater knob just binded up last week. how much were the parts ?

jdm phil Nov 8, 2011 07:01 PM

good thread

phi79 Nov 10, 2011 06:43 PM

Thanks for the video.

DontStopMe Nov 11, 2011 09:03 AM


Originally Posted by jr-mack (Post 9731013)
how much were the parts ?

Not much, I think it was under $25 shipped for both.

luvboost Nov 11, 2011 03:27 PM

nice! bookmarked

SpoolinUp Nov 15, 2011 10:36 AM

For those of you on the cheap (a friend of mines Lancer) that only have the bent cable issue, take all the gears off and clean/re-grease them as shown in the video. For the stock cable, straighten out where it bent. Then with a razor knife and wire strippers strip off 2.5" of the black sheathing. Now grab the soldering iron and fluxed solder, solder the exposed area lighty. Glide the soldering iron from one end to another, only leaving a bit of solder on the cable. Your main goal is to weep the solder into the cable rather than have it on the outside. So far this has lasted a full year on his car. Results may vary but it sure can't hurt to try.

badbob2121 Nov 15, 2011 12:50 PM

great job, thanks

this is such a common issue too

rhd-jon Nov 18, 2011 06:54 PM

fck yea mine is almost done thanx for this vid

Nizevo Dec 4, 2011 08:33 AM

Nice video {thumbup}

bilbojankins Dec 4, 2011 09:08 PM

Great video! I need to do this soon.


All times are GMT -7. The time now is 08:39 PM.


© 2019 MH Sub I, LLC dba Internet Brands