Nice Evo manny!!

 

Thanks Man!

 

Chillin


Bay


With wife's car

 

Here is an older dirty pic of my car... now sits lower and has more carbon goodness



My Mods are the following...
4G64 2.4LR Build:
*Engine Internals*
-Manley 10:1 comp. Platinum Series Coated LR spec Pistons
-Manley Turbo Tuff 156mm Rods
-ARP head, rod, and main studs/bolts
-ACL Race Rod and Crank bearings
-Manley SS 1mm oversized valves
-Manley Stg. 3 Dual Valve-Springs w/ Titanium Retainers
-Cosworth 272 M2 Cams
-Stg. 1 Head porting
*Engine External*
-SpoolinUp C.O.P. Kit
-Self Ported Intake Mani. W/ P2R gasket
-Full Blown 70mm Throttle Body
-STM EGR block off plate
-AEM adj. cam gears
-Gates Kevlar Racing T-Belt & A/C delete drive belt
-Balance Shaft removal kit
-New OEM oil pump, water pump, and tensioner
-Buscher modified Oil Pan w/race baffling
-Greddy Oil Catch Can
*Turbo Set-Up*
-Forced Performance HTA3586R w/ Garret 1.06a/r Twin-Scroll T4 hot side
-DNP SS Tubular T4 Twin-Scroll Manifold
-44mm Tial Wastegate w/ custom dumptube
-Custom 3" Downpipe w/ test pipe
-AMS Race FMIC w/ 4" Core w/ 2.5" IC piping
-Synapse BOV
-DEI Titanium exhaust wrap on manifold, dp, & dumptube
-LavaShield Turbo Blanket
-Custom 4" Intake w/ 9" K&N filter
*Fuel &Tuning Set-Up*
-1680cc Bosch Injectors
-E85 400lph+ Walboro Pump
-AEM Adj. Fuel Pressure Regulator w/ B&M gauge
-AEM Fuel Rail
-MAP 6AN SS fuel return line setup w/ STM adapter
-4Bar Omni MAP sensor
-SpoolinUp Speed Density conversion harness w/ IAT sensor
-Tephra version 7 w/ Speed Density
-AEM wideband, Autometer Boost & Oil pressure gauges
*Transmission & Driveline*
-Shep Stg2 Trans
-QuarterMaster 8-Leg Race version clutch w/ hydraulic release bearing
-TRE 12 plate Rear Diff
-Redline Fluids throughout
-Whiteline Rear Diff bushings
-STM Solid trans bushings
-ACD-Tuning Custom maps for track & auto-x
*Suspension & Brakes*
-Stance SS 15-Way Adj. Coilovers
-Hotchkis 24mm Adj Rear Sway-Bar
-Whiteline Roll Center Ball-Joints& Tie-Rods
-Custom 3"-2" brake ducting w/ Binary caliper adapters
-DBA 4000 Rotors front and rear
-EBC Red pads front and rear
-All SS Brake Lines w/ ATE Super Blue fluid
-18x9.5 Enkei NT03-M et27 in gunmetal w/10mm front spacers
-275/35-18 Toyo RA1s
*Aerodynamics*
-APR GTC-300 67" CF Spoiler
-APR CF Front Splitter (heavily reinforced)
-APR CF Canards (x4)
-APR Rear Diffuser
-DoLuck Front Spoiler/lip
-Rexpeed CF front air ducts
-Rexpeed Painted Vortex Generator
-Rexpeed CF Side Spats
-Rexpeed CF Bumper Exhaust Shield

 

Where do you run around here? If you see a silver IX with orange wheels, say hi!

 

Will do! I live in Great Falls but the evo rarley sees the street anymore, pretty much only on nice weekends or to a car show otherwise getting trailered to MIR, summit point, VIR... Ect.

 

Thanks again to a.m.n auto photography

 

Looking good Ron!

 

^ thanks Chris. I Will be happy when I put the swift spec r spring in next week and get a jdm rear. Deff. not a DSM but I am loving it!

 

Here is a pic of my 9 pretty much stock

 

And one more

 

I snapped a few more photos during an 8 am adventure when I woke up and just couldn't wait to go on a drive.

 

Now that's some beautiful scenery! Wish I could've been there.