The AMS Drag Car clone build!
It's too bad the cage doesn't follow the pillars better. I think you could pass a brembo caliper between the tube and the pillar. Looks great otherwise. I like the EMS mount, the differential mounts, and the staging brake setup.
I'll give you a tip. Don't weld in your floor plates first. Make and mark your floor plates on the chassis, then take a hole saw (I use a 3" hole saw) and cut a hole in the chassis. This way you can sink the cage to weld it. You don't end up with gaping spaces between your tubes and your chassis in the end and it looks 100 times better.
I'll give you a tip. Don't weld in your floor plates first. Make and mark your floor plates on the chassis, then take a hole saw (I use a 3" hole saw) and cut a hole in the chassis. This way you can sink the cage to weld it. You don't end up with gaping spaces between your tubes and your chassis in the end and it looks 100 times better.
