Ostar Motorsports Evo 9 "Street" Car build
#1
Newbie
Thread Starter
Join Date: Nov 2012
Location: Orlando
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Ostar Motorsports Evo 9 "Street" Car build
Here are a couple of pics I took of this Evo 9 build a few weeks ago. It took a good amount of man hours to get it there, but it was worth the time and effort. Hope you guys like them. The exterior of the car is pretty much stock other than the JDM rear bumper and lamps.
Last edited by Fernan 4G63; Jun 12, 2017 at 08:25 PM.
#4
Newbie
Thread Starter
Join Date: Nov 2012
Location: Orlando
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Thanks!
Here are the basics:
Magnus intake manifold
Kiggly springs and retainers
Ferrea Competition Plus valves
GSC S3 camshafts
L19 head stud set
Ostar Motorsports Stage 3 Short Block
Precision 6266 Gen 2
ETS hot parts kit
ETS intercooler
Quarter master twin disc
That's pretty much it for the engine. Car made 831whp and 587wtq at 39 psi.
Lol yeah it was the biggest we found. Took a bit of trimming but it worked out. IAT temps didn't see more than 79 degrees at 39psi.
Here are the basics:
Magnus intake manifold
Kiggly springs and retainers
Ferrea Competition Plus valves
GSC S3 camshafts
L19 head stud set
Ostar Motorsports Stage 3 Short Block
Precision 6266 Gen 2
ETS hot parts kit
ETS intercooler
Quarter master twin disc
That's pretty much it for the engine. Car made 831whp and 587wtq at 39 psi.
Lol yeah it was the biggest we found. Took a bit of trimming but it worked out. IAT temps didn't see more than 79 degrees at 39psi.
Trending Topics
#12
Evolved Member
The car looks so gorgeous bro.
I want to know about couple of things.
- The exhaust manifold looks such a tight fit, how did they install it ?
- Which radiator is this ? did you repainted it black ?
- Any mods to the front bumper to fit this huge intercooler ?
I want to know about couple of things.
- The exhaust manifold looks such a tight fit, how did they install it ?
- Which radiator is this ? did you repainted it black ?
- Any mods to the front bumper to fit this huge intercooler ?
#13
Newbie
Thread Starter
Join Date: Nov 2012
Location: Orlando
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Wiseco HD 10.5:1
Manley I beam
ACL Race bearings
Arp main studs
Manley 88mm race crankshaft
-It's a Mishimoto radiator that we refinished the tanks in black.
-We had to trim the front bumper a few inches in order to make it fit with the new intercooler.