Whiteline Max-C Camber Plates just released!!!
#82
Evolving Member
iTrader: (3)
Join Date: Feb 2006
Location: st paul/mpls MN
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
well I picked up a set of these (locally was cheaper than importing from the USA)
Anyway's after much stuffing around I was still getting spring binding which was causing a lot of noise in the cabin.
I emailed whiteline AU and they responded saying that they have put this product on hold until a revised product is bought out.
I think the problem is two fold:
1) There is not enough clearance between the bottom camber plate and the top spring perch of the coilovers - easily solved but adding a washer between the supplied spherical bearing adaptor and the perch.
2) I am not sure but I think the spherical bearing may be sticking under load, it spins fine when there is no weight on it - kinda hard to tell thou
So I am waiting for Whiteline to tell me what their plan is...
Anyway's after much stuffing around I was still getting spring binding which was causing a lot of noise in the cabin.
I emailed whiteline AU and they responded saying that they have put this product on hold until a revised product is bought out.
I think the problem is two fold:
1) There is not enough clearance between the bottom camber plate and the top spring perch of the coilovers - easily solved but adding a washer between the supplied spherical bearing adaptor and the perch.
2) I am not sure but I think the spherical bearing may be sticking under load, it spins fine when there is no weight on it - kinda hard to tell thou
So I am waiting for Whiteline to tell me what their plan is...
I get a lot of spring binding. I will try the washer and see if that helps. I am thinking the binding may have caused it, but I actually had the shaft of one of my KW coilovers snap... and the other side bend. I had them rebuilt and reinstalled. I am still getting the binding.
pic, because it did happen
also, anyone know if I can get replacement hardware for these? specifically the studs, deep nuts, and spherical bearing adapter
#83
Newbie
iTrader: (2)
Join Date: Apr 2011
Location: Orange County, CA
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
That's some pretty gnarly carnage.
As for the hardware, Whiteline should be able to get it for you. Otherwise take some measurements of what you need and just order it from McMaster-Carr
As for the hardware, Whiteline should be able to get it for you. Otherwise take some measurements of what you need and just order it from McMaster-Carr
Thread
Thread Starter
Forum
Replies
Last Post
Terror Rising
Project Cars / Build Threads
179
Jul 28, 2019 06:20 PM
guyver858
For Sale - Suspension / Brakes / Handling
3
Dec 31, 2016 04:22 PM
lbcevo
For Sale - Suspension / Brakes / Handling
0
Oct 27, 2016 12:30 AM