TQ solution rear toe arms question
#1
TQ solution rear toe arms question
I have replaced my rear toe arms with these and set them up per the photo they have on their website per the rep I spoke to at TQ solutions. After alignment the rear was not settling correctly and felt like it “skates”. I have now put the two spacers above the spherical bearing and it is now better but still “skates”. Any information on how to fix this? Current alignment specs on my 03:
front:
camber -2.5
toe 0
rear
camber -1.5
toe factory .24
The arms I have
picture from their website of how it was originally installed but had a “skating “ feel..
front:
camber -2.5
toe 0
rear
camber -1.5
toe factory .24
The arms I have
picture from their website of how it was originally installed but had a “skating “ feel..
#2
EvoM Guru
iTrader: (2)
Gee what a surprise, TS doesn't know how to set up their own product, maybe because they don't actually engineer anything they make. Pathetic copy/paste company.
OP the best starting place is to try and make the toe arm parallel to the upper and lower control arms. Depending on ride height and any geometry corrections will determine which way you need to go from there to minimize bumpsteer.
OP the best starting place is to try and make the toe arm parallel to the upper and lower control arms. Depending on ride height and any geometry corrections will determine which way you need to go from there to minimize bumpsteer.
The following users liked this post:
BrunoBoy650 (Feb 29, 2024)
The following users liked this post:
BrunoBoy650 (Feb 29, 2024)
#4
Dang ok. Thank you both for replying. I was going to go with a Megan or hardrace but thought TS was a reputable company. It’s really bad and not confident inspiring driving my evo. I will need to have it rechecked. It’s unfortunate as I would need to do another alignment. I’ll do my best to take a photo of it on the ground once it stops raining.
only other suspension bits done in the rear are
rear trailing arm bushing (whiteline)
Tein flex Z 10k rear
st 25mm sway bar with adjustable endlinks.
only other suspension bits done in the rear are
rear trailing arm bushing (whiteline)
Tein flex Z 10k rear
st 25mm sway bar with adjustable endlinks.
The following users liked this post:
BrunoBoy650 (Feb 29, 2024)
#6
just grease on them bushings
https://www.youtube.com/shorts/1c1-gt03oOk
https://www.youtube.com/shorts/1c1-gt03oOk
The following users liked this post:
BrunoBoy650 (Mar 1, 2024)
The following 2 users liked this post by deylag:
BrunoBoy650 (Mar 4, 2024),
WRC-LVR (Mar 6, 2024)
Thread
Thread Starter
Forum
Replies
Last Post
ChimpEvOX
Evo X Tires / Wheels / Brakes / Suspension
7
Jul 10, 2011 08:36 AM
DSMEVOLUTION
Evo Tires / Wheels / Brakes / Suspension
1
Mar 29, 2008 08:16 AM