Evo X Boost Gauge Install ,No splicing, No firewall drilling,Pics+Vid= Clean As Hell
#228
Newbie
iTrader: (6)
Join Date: Apr 2010
Location: Troy, Michigan
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
Might be a dumb question or one that has been answered before (I really have done a lot of research) but can you splice both an AEM boost and UEGO gauge into the cigarette lighter wiring and still be able to use it for charging phone or radar?
#229
Doing an electrical boost gauge soon, mine requires a constant power source between ON and ignition because the gauge goes through a calibration during startup where it 0's out - so I want a source that has constant power through on and engine startup, anyone know a good one?
#231
Soooo I hooked up the illumination wire to hazard lights and my gauge light was on when the car was off....no clue how it's working fine for the rest of you...just went through cig lighter instead.
#235
Evolving Member
iTrader: (17)
Join Date: Aug 2005
Location: Minnesota
Posts: 321
Likes: 0
Received 0 Likes
on
0 Posts
Nice - I used this to setup my Defi white racer and it worked great. For MR or SS package evos use the green with white stripe wire from the ASC button for dimming.
Last edited by stryderlis; Jul 20, 2013 at 06:16 PM.
#240
i have both aem boost and wideband gauges i want to run them to the a-pillar i guess the boost gauge i can run in the fender wall grommet but the wideband what grommet do i run that in and get the cable to the a-pillar?