From start to finish I had a blast with this build. Every build is always a learning experience building memories and life long lessons not soon to be forgotten especially from being a part of this community. A 3 year build for which I've been dreaming and wanting to do for a very long time! Hope everyone enjoys it! Comments and feedback are welcome...for that will only make the next one that much better



Link below for the full feature via NWMOTIV
http://www.nwmotiv.com/cars/feature-mario-chans-evo-x/

 

I love this car... Good job sir.

 

Very Clean! Props on the build!

 

Nice GG man! Good work!

 

amazing photography and nice car..

 

nice work. What are your specs on the wheels?

 

I like that start button. Was it easy to install?

 

so what's next? car looks good.

 

I smell bimmer. Good looking Evo X. Thumbsup for the local love.

 

They're iForged 19x10+35 Dig in to the details on that page...

I have a question about the harness bar, it looks like a quick removal, is it?

 

Bumpin this cause I still want to know about that harness bar.

 

I'm wondering if the start/stop button works and if it's for the ignition.

 

Thanks for the comments and feedback guys!

Yes they are iForged NEO Three Piece Custom Barreled Wheels to have the staggered look but are in fact the same offset front and back!

The harness bar is removable. Some trimming had to be done to the B Pillar though. Speedware Motorsports made the bar or me off of my modified design I provided them. They spec and make harness bars for Sparco

The engine start button is hooked up to ignition that is correct through a custom wire job!

 

Can you share the wiring for the start and stop?

 

I was hoping it was a no-trim removable bar, but I still like it.

Looking for something I can throw in on autocross days and remove daily driving.