Help the electrically challenged (me)!
Thread Starter
Evolving Member
iTrader: (28)
Joined: Jan 2004
Posts: 346
Likes: 0
From: Pasadena, MD
Help the electrically challenged (me)!
>Help me make this.<
I wish I just bought this instead of the MAP sensor alone. Didn't know the sensor was so tiny. Thought I could just solder wires to the pins. This thing is only around 1/2" X 1/2". I only need to connect 3 out of the 8 pins to the circuit board thing.
I wish I just bought this instead of the MAP sensor alone. Didn't know the sensor was so tiny. Thought I could just solder wires to the pins. This thing is only around 1/2" X 1/2". I only need to connect 3 out of the 8 pins to the circuit board thing.
