EvolutionM - Mitsubishi Lancer and Lancer Evolution Community

EvolutionM - Mitsubishi Lancer and Lancer Evolution Community (https://www.evolutionm.net/forums/index.php)
-   Marketplace (https://www.evolutionm.net/forums/forumdisplay.php?f=371)
-   -   2003 Mitsubishi Lancer Evolution (https://www.evolutionm.net/forums/showthread.php?t=751953)

ladiesman285 Nov 24, 2018 07:40 AM

2003 Mitsubishi Lancer Evolution
 
2003 Mitsubishi Lancer Evolution 8
Up for sale is a mostly stock vehicle with a lot of potential. Has been a daily driver this past summer and is very reliable.
150k on chassis and driveline
10k on built engine

Clean title in hand
Engine build specs:
0.020" overbore, honed and decked block
Manley platinum series (606005C-4) forged pistons
Manley H beam rods (14022-4)
ARP Head studs
ARP Main studs
ARP Con rod bolts (stretch gauged)
Cylinder head decked/machined for valve seating
Only genuine Mitsubishi parts used for engine build including
timing belt assembly and all gaskets and seals.
Balance shafts intact with new bearings and driving belt.
New OEM turbo cartridge
New OEM radiator
AEM 320 Liter per hour fuel pump
Mishimoto front mount intercooler
OEM Exedy Clutch kit installed 10k miles ago with engine rebuild
Rear Differential and Transmission fluid changed with respective Mitsubishi Diaqueen gear oils

Bilstien MR struts
Whiteline polyurethane lower inner front control arm bushings W0593
Whiteline KCA395 roll and bump steer kit
MR Taillights.
Rally Armor mud flaps

Recently Fluid filmed Underbody
Recently maintained with brake job (rotors and pads)
Cabin air filter installed ( Evo 8's did not come equipped with originally)

ABS disabled (right rear wheel speed sensor needs replacement) hence ABS light

Rear Bumper has small paint chip


Vehicle has been kept primarily stock for longevity and reliability. Paint isn't perfect but no major rust nor body damage only light scratches and small dents. I've driven the vehicle sparingly and only put on 10k miles following engine rebuild. Compression ratio kept same as stock and runs fine on stock tune. Contact for any questions. I have receipts, photos and clearances/tolerances of parts installed.

Not interested in trades.
Text at 810-280-2658

ladiesman285 Dec 9, 2018 01:09 PM

bump
 
bump

AWD Problems Dec 15, 2018 01:05 PM

do you have paperwork of the build

ladiesman285 Dec 16, 2018 09:14 PM

Updated with Build specs and reciepts


All times are GMT -7. The time now is 11:39 AM.


© 2024 MH Sub I, LLC dba Internet Brands