klever

iTrader: (15)

Hi, I just bought a MAP O2 Dump DP how seems to have a dent near the 02 sensor bung is that normal, just checking, did a test check on the car and seems to have plenty of clearance just really do not why the dent is there...Thanks

klever

iTrader: (15)

any word guys??

boost_injected

I'm gonna go ahead and say it is something in their process of fabricating these pieces because I just got mine a few days ago and I have the EXACT same dent in the same place as yours. Maybe someone else can chime in as to the reason behind it. I do industrial fabrication and I can't figure out a reason that it's necessary.

lostsoulsevo

iTrader: (10)

mine is also like that, its normal...i've already asked the question!!

TommiM

iTrader: (19)

Is it from the process of when they are forming the bends?

lostsoulsevo

iTrader: (10)

yes

ChrisCarey

iTrader: (38)

It is clearanced to allow easier installation of the rear stud/nut, earlier versions did not have this but after several complaints about install difficulty this was the solution.