wholly heavy batman, that more math than i signed up for tonight... racing has it's place, but why not make a super efficient smaller application instead of turbos bigger than my head?

The new project is about to finish.

Here are some general pics of the custom parts that we have for the 4g63.
We have steel rods, aluminum, titanium and our new custom rods are from Metal matrix composites (MMc). A quick reference for mmcs: its combination of metal (alloy) and ceramics, almost 40-60 better tensile strength than aluminum, the composite ceramics add a lot of strength to the rod comparing to anything exists, its 50-70% lighter to a steel same length and 25-35% to a titanium. The problem is the cost and the life of this rod. In a race condition rotating more than 35sec in 1.7ratio and 400grm of the piston have almost 100-120hours life. No bearings use with this rod as the MMC has less friction and wear than traditionally used Bronze. The cost per set is calculated by the time of producing.

We have piston - rod combos from 1.7 ratio to 1.9 ratio (for 12.000rpms.)
Lightweigth pistons and heavy duty methanol pistons from 11.8:1 cr to 13.4:1cr with chromemoly forged pins and gapless plasma rings. (these are tested to 79psi boost).


http://img59.imageshack.us/img59/2430/mmc.jpg

http://img44.imageshack.us/img44/699...kvscustom1.jpg

http://img85.imageshack.us/img85/9480/custom1k.jpg

http://img85.imageshack.us/img85/3922/customo.jpg

http://img268.imageshack.us/img268/6...ckvscustom.jpg


Coming our custom ported high flow cylinder head, composite titanium valves and high silicone valvetrain components, berilium valve seats and guides etc.
Pictures and infos coming soon.



Spyros
Extreme Tuners

looks like somebody has been doing the math{thumbup} good job!

cant wait to see this thing in action!

That business card holder is fricken sweet!

Well I will be stoppping by when I visit Greece this summer with my friend and his family.

I am at a loss for words, i honestly dont even know what to say

BTW, What suspension are you running with such a heavy front end??

Ill!

Just a quick shot of the high flow cylinder head.

Custom Titanium valves, custom berilium valve seats, cobalt valve guides.
Capable of 12.500rpms. 6.3G acceleration.

More pics and specs coming.



http://img5.imageshack.us/img5/3448/cylinder.jpg




http://img94.imageshack.us/img94/4258/cylinder1.jpg




Spyros

What springs do you plan on using to try and keep those valves from floating at 12,000 rpm plus? Any cam specs : )

This project will not need to rev so high rpms to reach our hp target.
But this cylinder head is capable. we ve done it in the past.
Next i will post springs and retainers for 12500rpms.

700 extra useless hp.imo once you make 700-800 hp its good enough on the evos drivetrain.Those are some really nice parts i must say.1400hp should be pretty interesting in my 4g63 rwd project.

wow insane parts u guys have there

wow