just to play it safe to be honest. no ref. atleast in my case.

I'll look for all the 23psi runs I have on Reds and post some stuff tomorrow or tuesday then {thumbup}

cheers man:beer:

can anybody compare a gt35r and a precision 6265? which is more powerful? spools better? which gt series is 6265 equal to?

400whp on 91 octane with about 22-23psi of boost

Didnt really have a 23psi pull I could find that I could say I knew was a red for sure. This one I did yesterday so i know exactly what one it was. I will get a little more in detail with my license plate to mod list.

http://img.photobucket.com/albums/v5...c/24psired.jpg

thanks for the graph john. so i assume this was done on stock boost level (tough to tell from the graph)? and do u know if the owner was using an mbc or the stock solenoid?
that is some nice power btw

AEM tru boost, boost falling from 24 peak to 21.5ish out the top with a timing map you can run 91 on if you want.

removed so hp gods wont read (incase they can read)

search some.

Do you know Khalid Naeem in Lahore? He has a massively fast Evo (8 I think), and can probably offer local help and advise (Unless you guys are major street racing rivals already!). His sign-in is "Khalid" on evom. He makes in the 500+ range with Bushur 35R turbo etc. Here is a youtube vid from his page: http://www.youtube.com/watch?v=Bx3cVuMOCsI

John, may I ask what hardware do you have on that car making this much power? I guess I read FP red, what cams and other mods do you have in there?


PEACE
NAB

Nab,

That one was stock bottom end, Cosworth M2s (not my favorite), Speed density, FIC 850s, EnglishRacing intake pipe, ETS intercooler and intercooler pipings, Buschur exhaust I believe, and a TiTek O2 housing as far as I can remember.

Another one of those "how much threads..."
 

2006 Evolution IX MR 30k on the motor.
How much should I make on my current setup with an FP Black.

TBE 3" exhaust
Ported turbo manifold
DNP port 02 housing
DTM 3.5" FMIC
ETS IC piping (ordering soon)
Ported intake manifold
ported/blueprinted head
Cosworth M3's (280/272)
will be getting 65mm throttle body
stock block

I know I'll need injectors to complete my setup but just want to know how much I should expect. Trying to decide between getting an HTA35R kit or an FP Black. The car is being built for track and weekend street cruises. It is not a daily driver for the most part.

Depends on how much boost you're planning to run and how hard you want to push that stock block.