Just driving it to work everyday.Knocking too much on low boost...

Took an antifreeze bath while putting on lower radiator hose....

Detailed the exterior, completely different car

BUMP

A buddy came over and helped me put the finishing touches on a radiator cooling pannel i built out of some stainless steel.

My car got loaded up into a trailer on Monday to head to Ohio.

Yesterday:

Did a quick hand wash of the vehicle to get enough dirt off to test "Scratch Out" on some of the worst spots. Amazing stuff. I'll have to wash and dry the car properly and do the whole body.

Today:
Jacked the front of my parts car and managed to remove the front-right Tein coilover. The rotor is crooked and was disinclined to come off. I'll need to do some more research to remove/disassemble the wheel hubs as well. I think my DD has worn front wheel bearings.

got my act clutch,trans mount, fork stop, ss clutch line. wont go in untill the end of the month so i just washed my car and said dont worry no more slipping when drivin.

Saturday: Started the tear down to do the 60k service

Sunday: Got the crankshaft timing belt sprocket off (with an impact) and the acc belt idler pulley off (with an impact). Then the rain came (no garage working in my driveway)

Monday: Got water pump changed and new gates kevlar balance belt installed

Tuesday: Got new gates kevlar timing belt installed (everything in time...UGH had to make an SOS call to a buddy to come help me do that)

Hopefully tonight it won't be raining when I get off work and I can get the new gates acc belt on and get it buttoned back up and refilled with coolant and running.

Trying to get this damn o2 sensor of the o2 housing....

Drove to the park and ride and took the bus... LMAO!

Drove it in the pouring rain and marveled at how stable it feels and how well it drives in inclement weather.

full stiff on rsb- trying it out vs the middle setting

plastidip ftw? or ftl? :-/

http://i44.tinypic.com/iombn6.jpg

I plasti dipped my wheels too {thumbup}. The stuff is great and it holds well. Protects from rock chips and stuff too. Peels right off and you can do it all over again. Just wish they had gloss black plasti dip.

I know this is tomorrow but going down to English Racing to get new Comp clutch {thumbup}.

can you post up the part no. for the leds and reverse lights and where you got them?