Haha, thanks! You should have seen it when I bought it two weeks ago. So far I have lowered the front tint from 5% to 35%, changed the the blacked out tails to Evo VII tails, changed the blacked out corner markers back to clear, and added just a little bit of color to the rims.

replaced pcv valve....easiest thing i have done to date....

Pulled the engine to fix a few spun bearings..:crap:

My front left wheel hub bearing is getting really bad; it sounds like a grinding rotor. Today I concluded that I don't have the knowledge or time to swap in my hubs (with ABS sensors, which are missing my from POS car) from my parts car without some assistance.

Spent four hours doing the following:

Tranny fluid change
Coolant change
Sparkplugs change
Cleaned MAF sensor
Used Seafoam for intake
Cleaned intake filter
Mounted license plate

Car has improved in the following areas:
Better throttle response/runs smoother :)
Improved RPM idle
Shifts smoother

Removed my carpet, got rid of my exhaust heat shield that was vibrating against my o2 sensor and found a gravel parking lot to play in. Building a rally car is fun!

Fix the ABS lights and my ACD light not coming on. that im having problem with for the last 3 weeks.

Trans and rear diff fluid change. My filling "apparatus" doesn't really allow me to get to the transfer case at the moment, I need to get my proper setup back to finish up the deal (it's at a friend's house). Haven't driven it yet, not expecting much change really. Fluid looked good coming out and my trans drain plug was actually very clean, to my surprise.

Plasti dipped my front bumper

Put on my Coilovers and got a fender roll :D

BOOOST LEAK CHECK.... crazy how many leaks on my buddies car!! Everyone should do it asap!!!!!!!!

As for my car, the wire removal/de-pinning has begun lol what a mess :(

Gave her a bath cause it looked like a rally car haha its been raining a lot!

changed the boots on my front axles. basically a half rebuild lol. everything oem.

https://fbcdn-sphotos-a.akamaihd.net...17057167_n.jpg
https://fbcdn-sphotos-a.akamaihd.net...91076404_n.jpg

now i gotta wait for that seph trans to come ( 2 weeks and half ) to put on my twin disc and a few other things.

https://fbcdn-sphotos-a.akamaihd.net...14356798_n.jpg

https://fbcdn-sphotos-a.akamaihd.net...18973701_n.jpg

decided on a direction I'm going to go with the car so I can start ordering parts :)

And that's bad how? Haha.