Moose’s Evo 8 Rebuild
#17
Evolving Member
Thread Starter
Mounted the fenders and splash guards.
still need to replace my driver side headlight.
still need to mess with body lines /fitment on passenger side because it was hit on that side during previous ownership.
also found these scratches on the balance shaft but finger nail test I don’t feel anything. May replace I don’t know yet. Sorta concerns me a little and yes I’m keeping them, it’s a stock motor with bolt ons not revving to the moon.
The following users liked this post:
huzzle101 (Feb 16, 2019)
#22
Evolving Member
Thread Starter
Finished tear down of my old motor and I’m going to store it away for another project down the road... I have a brand new complete shortblock coming from Daytona Mitsubishi, so I can still enjoy the car and drive it around reliably. I have to take care of some personal/business things that will need a lot of my time and attention.
The following users liked this post:
japspec (Mar 26, 2019)
#23
Evolving Member
Thread Starter
Didn’t do much today , getting ready for a small little get away for a few days. I did however get something done that’s been bothering me for a little while.
Cut some threads into this inlet nipple
Installed little brass hose barb fitting.
I was thinking of using 3m silicone on threads but i don’t think it will cause a leak at all and if it does I’ll put the 3m stuff on then.
Cut some threads into this inlet nipple
Installed little brass hose barb fitting.
I was thinking of using 3m silicone on threads but i don’t think it will cause a leak at all and if it does I’ll put the 3m stuff on then.
Last edited by Moose_421; Feb 19, 2019 at 04:26 PM.
#30
Evolving Member
Thread Starter