Mark this thread as Unsold
[FS] OZ/ES/Lancer Wilwood BBK - rotors, calipers, mounting h/w, braided steel lines
#1
OZ/ES/Lancer Wilwood BBK - rotors, calipers, mounting h/w, braided steel lines
Selling my Wilwood front BBK (#140-7015-DR) for an alternative setup (EVO brembos)
This was a major upgrade over stock. I'm selling the complete kit - includes oversized rotors, billet calipers, pads, all mounting hardware and stainless steel braided brake lines. About 3,000 miles of use. Rotors have a bit of surface rust as the car hasn't been driven for a while, but it will scrape off once they are used again.
If you have a Ralliart, you could likely just buy a brake hat from Wilwood similar to the 170-6996 to match your bolt config.
Make me an offer!
EDIT: forgot to mention, you'll probably need higher diameter than 15" for these to fit. I had 16" wheels and the kit fit fine, but it wouldn't fit with the stock OZ wheels.
This was a major upgrade over stock. I'm selling the complete kit - includes oversized rotors, billet calipers, pads, all mounting hardware and stainless steel braided brake lines. About 3,000 miles of use. Rotors have a bit of surface rust as the car hasn't been driven for a while, but it will scrape off once they are used again.
If you have a Ralliart, you could likely just buy a brake hat from Wilwood similar to the 170-6996 to match your bolt config.
Make me an offer!
EDIT: forgot to mention, you'll probably need higher diameter than 15" for these to fit. I had 16" wheels and the kit fit fine, but it wouldn't fit with the stock OZ wheels.
Last edited by doncarbone; May 30, 2015 at 10:11 PM.
#4
Does this look about right for your car? Details on kit: http://www.wilwood.com/BrakeKits/Bra...+(4+x+114.3mm)