Originally Posted by 3SgteGuru

Mine always resets back to the incorrect values when i close ECU Flash

Originally Posted by stunt2

which xml should I edit, evo7base too, or TephraMOD-96530706-v7 ?

Originally Posted by merlin.oz

the correct eval is:

6.25*x/64

not 6.29*x/64

If the stock max Hz axis value is 1610Hz, you have the the incorrect 6.29*x/64 in your definition.

Originally Posted by merlin.oz

That looks right,
but
It is not a good idea to edit you xml using EcuFlash to do the editing, as it will delete any comments and notes embedded in the xml, and space/tabs.
Essentially, it will trash your xml down to only what EcuFlash needs to work.

So, if you were using one of my xmls for example, which have lots of tuning notes embedded in the definition, those comments and notes will be deleted.

That is why I always advocate using Notepad or Notepad++ to edit a definition file.

Originally Posted by mines5

Tried to rescale MAF Hz left column but it didn't work.

I rescaled MAF Hz in 9653 but in 9417 i am unable to do so.

The MAF hz scaling is correctly defined but when i try to change it [ e.g. 0x2200 ] it becomes 0.

Please advise.

Originally Posted by cdrinkh2o

Check your 9417 XML to make sure you have the right scaling code in it for MAF Hz. What you describe happens when you are missing the required scaling XML code. Also if you are trying to replace the 1600 Hz value with 2200, you don't need to enter the value as 0x2200. Just key in 2200.

Originally Posted by cdrinkh2o

It seems like you didn't read the whole thread slacker! The answer is on the first page.