Check engine light
#1
Evolving Member
Thread Starter
Check engine light
Hello,
I had my 2015 Evo X tuned about 4 months ago with minor bolt on. Just recently, my engine service soon light came on. I took it to Autozone and the code they retrieved had something to do with my catalytic converter. I turned off the service soon light and couple days later, it came back on. I did install a Berk HFC before the tune and everything has been great up until now. Also, with the tune and bolt on, the power difference didn't really wow me. Dont know if it was just me or maybe something is wrong with the car? Maybe because the tune was a conservative tune?
Someone wants to chime in on these reasons?
List of mods
-AEM Cold Air intake
-Grimmspeed 3port boost controller
-Tomei titanium single catback
-Berk HFC
-Ultimate racing upper intercooler pipe
I had my 2015 Evo X tuned about 4 months ago with minor bolt on. Just recently, my engine service soon light came on. I took it to Autozone and the code they retrieved had something to do with my catalytic converter. I turned off the service soon light and couple days later, it came back on. I did install a Berk HFC before the tune and everything has been great up until now. Also, with the tune and bolt on, the power difference didn't really wow me. Dont know if it was just me or maybe something is wrong with the car? Maybe because the tune was a conservative tune?
Someone wants to chime in on these reasons?
List of mods
-AEM Cold Air intake
-Grimmspeed 3port boost controller
-Tomei titanium single catback
-Berk HFC
-Ultimate racing upper intercooler pipe
#2
Evolved Member
Probably a P0420? Catalyst efficiency below threshold?
Probably caused by the high flow cat. The rear 02 sensor is telling the ecu that the catalytic converter is not converting the unburnt fuels.
If the car is on tephra rom you can force the CATALYST monitor as passed or ready so it wont set codes......
Probably caused by the high flow cat. The rear 02 sensor is telling the ecu that the catalytic converter is not converting the unburnt fuels.
If the car is on tephra rom you can force the CATALYST monitor as passed or ready so it wont set codes......
#3
EvoM Guru
iTrader: (8)
Probably a P0420? Catalyst efficiency below threshold?
Probably caused by the high flow cat. The rear 02 sensor is telling the ecu that the catalytic converter is not converting the unburnt fuels.
If the car is on tephra rom you can force the CATALYST monitor as passed or ready so it wont set codes......
Probably caused by the high flow cat. The rear 02 sensor is telling the ecu that the catalytic converter is not converting the unburnt fuels.
If the car is on tephra rom you can force the CATALYST monitor as passed or ready so it wont set codes......
#4
Evolved Member
Thread
Thread Starter
Forum
Replies
Last Post
blkboyan1486
General Engine Management / Tuning Forum
6
May 25, 2007 03:49 AM
blkboyan1486
Evo Engine / Turbo / Drivetrain
9
May 25, 2007 01:53 AM
olschool
04-06 Ralliart Engine/Drivetrain
14
Apr 4, 2006 07:56 PM
Az3ar
Evo Engine / Turbo / Drivetrain
3
Jun 16, 2004 11:05 PM