Skunk 2 Bolt on Intake Manifold!!!!!
Jun 30, 2009, 02:42 PM
#1
Skunk 2 Bolt on Intake Manifold!!!!!
We have a few of these in transit to us, 100% bolt on. Please Pm me for special intro pricing!!
Car is 2006 Evo 9. Car has a completely stock bottom end so we didn't want to push it to far. Car still has allot more in it. As you can see the car is having a little trouble holding boost when we tried turning it up. We think the actuator is going bad.
Mods:
FP Red
Cossie M2 cams
Supertech single spring/retainer kit
Shearer 02 dump
3 inch turbo back
ETS piping kit
ETS 3.5 intercooler
Custom COP kit FIC 2150's
Full blown double pump kit
Skunk 2 Intake Manifold
Here is before and after, boost went down a little on the after run but it still made more power
Before and after with torque reading. We also tried to turn the boost up a little but it would not hold because of the actuator
Same run as above only with boost plot instead of torque reading
Last edited by Chris@nolimitmotors; Oct 28, 2010 at 02:04 PM.
Jul 1, 2009, 06:33 PM
#4
Really nice. I like that. I wonder what the runner diameter and lenght compares to a map or wilsons ported intake manifold. It seems they just centered the plenum instead it being off set like stock with equal length runners. Some additional porting and it'll be mint. how much are these going for ?
