Greetings. Has anyone put together a two tone mesh grill. It is past time for me to make a change and get rid of the plastic look. I have a Yellow RA and I am thinking that if I could obtain a black and red mesh to replace the plastic it would look pretty sharp. Any ideas out there on where or how to go about this?

Regards
EJM

 

Check the black ralliart show 'n shine forum, I seem to remember someone in there had a red mesh grille with black surround. The picture is of his RA drifting around a corner.

 

Like this

http://www.nepthys.com/artofrally/

 

Thanks alot for the replies. I am thinking for a black & red mesh that will show a pattern something like our seat upholstery. (black wire at one angle and red for the other and crossing over. I will think about the all red though as I am planing on doing my calipers.

Regards all
EJM

 

no mix, but this may be a good start:

http://www.g2usa.com/grille.shtml

anodized, not painted so it wont chip away.

I am thinking of doing blue on my TG /w blue calipers, but i think the blue grill might be a bit too much. maybe i'll just stick /w black