Official "Lightning Yellow" Picture Thread
Newbie
Joined: Jan 2011
Posts: 42
Likes: 0
From: Vancouver BC
Installed SRI from AEM. Took about 1 and 1/2 hours.
Black Tails from RRM, will probably debadge to clean up the trunk when I got time again. I stuck the Ralliart badge on the frame haha... don't know where else to throw it =P
The stock pulley was 3-4 lbs and the new one is just over half a pound. I feel moarrr power from Low gear + low rev, and it complimented my SRI quite nicely, it sounds really good around 3000 rpm now
Black Tails from RRM, will probably debadge to clean up the trunk when I got time again. I stuck the Ralliart badge on the frame haha... don't know where else to throw it =P
The stock pulley was 3-4 lbs and the new one is just over half a pound. I feel moarrr power from Low gear + low rev, and it complimented my SRI quite nicely, it sounds really good around 3000 rpm now
Newbie
Joined: Dec 2012
Posts: 0
Likes: 0
From: New Zealand
Lancer Ralliarts from down under a.k.a the "Lancer VR-X"
My 2006 "Wasp Yellow" Lancer at Petone Beach, New Zealand, with rear lip and black stripe decals:
My 2006 "Wasp Yellow" Lancer at Petone Beach, New Zealand, with rear lip and black stripe decals:
Last edited by DisioNz; Dec 25, 2012 at 12:46 PM.
Newbie
Joined: Nov 2011
Posts: 27
Likes: 0
From: New Zealand
Joined: May 2011
Posts: 1,732
Likes: 9
From: So. Jersey (San Diego native)
