Is this a good exhaust for the RA? Also is anyone selling one?

 

I've read it is pretty quiet and close to stock sound. check classifieds for anyone posting exhausts for sale. GL

 

I have a custom TBE exhaust with a HFC (not just a catback) with magnaflow mufflers and a good sized resonator in the stock location. It's deeper and I'd say about 30% louder than stock and only cost me about $500. Look into getting one made.

 

I just installed the magnaflow cb on my ralliart. I like it so far, it's louder then stock and doesn't sound like a airplane.

 

How is it now that you've had it a few days? Would you recommend it?

 

My RA came with the Magnaflow CB on it and I like the way it sounds. Deep but not too loud. Everyone says it sounds good so far.

 

I have had it for a few months and here are my thoughts.

1,) It gets louder over a few months, it starts out maybe 15% louder than stock
2.) After a few months it is 30% + louder than stock
3.) There are TWO clamps that are used. One for the axle back and one for the muffler inlet. No matter how tight I clamp them there is black soot there where it obviously leaks. Didn't smell anything, didn't hear anything. My kid still seems smart (he is only 3).
4.) I will be taking it to a shop to weld and remove the two clamps - that is the only design flaw

positives

1.) Nice stainless 3"
2.) Factory layout - uses both bumper cut outs
3.) Not fart sounding, deep tone
4.) no banging or contact areas - uses factory hangers

 

I had a shop install mine because my factory bolts were welded on. I haven't noticed any black markes by the clamps yet but will keep a eye on it. It could be a tad quiter but not overly loud as is. May add a resonated test pipein the future.