It's getting warm so its time to start up the projects.
Whats your thoughts.


By gccruz at 2012-03-11

By gccruz at 2012-03-11

By gccruz at 2012-03-11

By gccruz at 2012-03-11

By gccruz at 2012-03-11

By gccruz at 2012-03-11

By gccruz at 2012-03-11

 

Awsome! why has no-one thought of that? Lets block all our factory gauges with a steering wheel mount... uuuh no!The ones that go on top of the gauge cluster look like butt poop! I like the a pillar mounts, but this is less obstructive! I bet people would buy those.

 

maybe double hump it, so it mimics the stock cluster shroud?

 

I like it. I would buy it.

 

That does look very nice. I think that if the "finish" includes a small edge detail like the oem gauge cluster it would look awesome. It may not need two humps but maybe just one gentle curve from one side to the other may make it more seamless or it may ruin it. When I visualize it, it could go either way.

 

looks awesome! i know this is just a rough design, but gauges slightly angled towards driver?

*i would buy this*

 

It is looking good. A slight angle towards the driver and the double-hump look would finish it off.

Oh, and wash your hands after sanding it before you hop in your car!

 

honest comment: I find it a little bit too big. it would be better if it's not taller than the OEM cluster.

 

its the way the dash slopes up. its only about 3.5 in tall. I had to make that tall to allow defrost.

 

they do. its just not noticeable in the pics. I'll try to get another few pics friday

 

You're actually right. I just check back on my own setup, it's quite tall as well. I guess it's just the angle your took the picture that confused me.

btw here is my setup:

 

My inspiration! Didn't remember where I had gotten the idea. Thank you

 

Here's an idea of how to handle the vent. The pod would come flush to the dash panel (about 2 more inches forward).

 

^^FAncy!

 

A short video to show defrost airflow.
https://www.youtube.com/watch?v=VZki...e_gdata_player