switched map and car wont start, help!!!

Reply Subscribe

Thread Tools

Search this Thread

Jul 13, 2007 | 09:45 AM

Steve@NoLimitmotors

Thread Starter

Account Disabled

iTrader: (53)

Joined: Nov 2004

Posts: 610

Likes: 0

From: LI, NY

switched map and car wont start, help!!!

So i switched to my race gas map on my AEM on my evo 9 and now the car wont start, turns over but never starts. Any simple ideas before i start goin crazy???

--Steve

Jul 13, 2007 | 09:48 AM

tweakdsm

Evolved Member

iTrader: (38)

Joined: Nov 2003

Posts: 2,407

Likes: 5

From: Illinois

open the old map and look into immoblizer code? and check the new map if they match.

Jul 13, 2007 | 10:20 PM

Aby@MIL.SPEC

Former Sponsor

iTrader: (161)

Joined: Jun 2003

Posts: 3,043

Likes: 13

From: San Elijo Hills, Ca.

1st put the old map in & see if the car starts

compare maps & see what is different besides the basic "tune" stuff.

be sure that the file is of similar strategies?

Jul 14, 2007 | 08:47 AM

alpha

Evolving Member

iTrader: (3)

Joined: May 2005

Posts: 304

Likes: 0

From: Florida

Steve. Upload the old calibration to the AEM EMS. Go to File -> Compare ... -> File the new file you uploaded that wouldnt start the car. Spark? Fuel?

Jul 15, 2007 | 10:10 PM

2JZfan

Evolving Member

iTrader: (5)

Joined: Sep 2006

Posts: 109

Likes: 0

From: Omaha, NE

If you haven't figure it out already, check the basic parameters while cranking: engine speed and stat sync'd. If you aren't getting good values for both, you'll never start regardless of fuel and timing.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last