First time evo VIII at 1/8
First time evo VIII at 1/8
I own a slightly modded evo 8. Your basics tbe no cat.....fuel pump...flash....21lbs.....intake thats about it nothing speical with an exedy stg4 twin disk.....how are the times looking just curious to the evo community.....and where can i improve.......advice is greatly appericated
r/t .649
60' 1.940
330 5.493
1/8 8.488
mph 84.05
r/t .513......almost perfect ;-)
60' 2.020
330 5.666
1/8 8.708
mph 82.72
r/t .391.....way red
60' 1.894
330 5.541
1/8 8.666
mph 81.34
r/t .688
60' 1.877
330 5.652
1/8 8.764
mph 81.07
r/t .533
60' 1.885
330 5.669
1/8 8.851
mph 77.41
r/t .704
60' 1.899
330 5.504
1/8 8.520
mph 83.90
r/t .649
60' 1.940
330 5.493
1/8 8.488
mph 84.05
r/t .513......almost perfect ;-)
60' 2.020
330 5.666
1/8 8.708
mph 82.72
r/t .391.....way red
60' 1.894
330 5.541
1/8 8.666
mph 81.34
r/t .688
60' 1.877
330 5.652
1/8 8.764
mph 81.07
r/t .533
60' 1.885
330 5.669
1/8 8.851
mph 77.41
r/t .704
60' 1.899
330 5.504
1/8 8.520
mph 83.90
Honestly, when you are first learning to drive the car, pay very little attention to the R/T. Concentrate on the 60fts more than anything.
The base 60ft you should be shooting for is 1.800sec. Anything less than that is room for improvement. Good job though if this is your first time out.
The base 60ft you should be shooting for is 1.800sec. Anything less than that is room for improvement. Good job though if this is your first time out.
Originally Posted by 03silevo
how can i improve that lol???? all launch right im guessing?
I see you have a flash. Does it have the 2 step rev limiter for 6050 rpm's? If so just launch off that. Let the clutch out just a little until you can almost feel the driveline catch then slip it all the way out quickly. Lower the psi in your tires as well. with that twin disk you should be pulling 1.6 60ft times.
yeah i have the dynoflash launch control but like i said that was my first time at the track so i am still learning.......i plan on goin in 2 weeks again by then i will have my comp 280's in......btw i go out to manassas you should head out i notice that your on dcevoclub every wens.....test n tune 6-8 pm
Trending Topics
Originally Posted by 03silevo
yeah i have the dynoflash launch control but like i said that was my first time at the track so i am still learning.......i plan on goin in 2 weeks again by then i will have my comp 280's in......btw i go out to manassas you should head out i notice that your on dcevoclub every wens.....test n tune 6-8 pm
thanks well i plan on getting a utec sooner or later lol......thanks though so you are happy with the cams thats awesome i got them ordered should be in by the end of this week
Originally Posted by 03silevo
thanks well i plan on getting a utec sooner or later lol......thanks though so you are happy with the cams thats awesome i got them ordered should be in by the end of this week
Please don't bother with Manassas. It's a terrible track that doesn't time properly. 1/8th mile is worthless anyway. Go to Capitol, Mason Dixon, or MIR to get some real times. We (DC Evos) tried going there 2 times, but we never went back after that due to how crappy it is. I drove the ever-living crap out of my car there, but I could never drop below 8.0 in the 1/8th, and I could never get above 84mph due to 3rd gear running out right near the end of the track.
I went to Capitol right after that and immediately ran 7s in the 1/4 with low 12s.
I went to Capitol right after that and immediately ran 7s in the 1/4 with low 12s.
Originally Posted by 03silevo
yeah i just wanna go there to get some experience before i go make a fool out of myself somewhere else..
Warrtalon is right, Manassas does suck. You should just run at Capitol or MIR. MIR is a great track. If you get there early on a Friday you can get about 6 runs in usually.
You will be really happy once you get cams for your car. I have the Comp 280's and are pretty satisfied. You will run low 12's for sure once you get your launch down.


