Mods:
• The Shop Built 2.3 Liter Built, Thanks Jimmy and Kenny!
• RRT Transmission with 4.0 Gear, Thanks Raif!
• FF Shearer HTA94 kit
• Magnus Intake w/ 65mm TB
• Buschur twin fuel pumps, ID2000 injectors
• English Racing Ported head, stock size valves/GSC S3 Cams , Thanks Aaron!
• AEM EMS 1

This was on Street tires and 592 whp and was immediately ejected from the Track LOL ..

(more details on previous post)
https://www.evolutionm.net/forums/ev...o-session.html

 

did you roll out of the whole??? car is fast good luck

 

Thanks man! Basically rolled out the hole, I slipped the clutch not to bog. Then just floored lol. I'm pretty sure I could have gotten it to a 1.7 60ft with some practice, but they didnt want to give me a chance. I was pumped after the techs blocked me in and told me I went too fast. But at least I was able to see the potential of the car on pump gas.

 

I didn't know that rolling out is against track rules.

 

I use to roll and break the beams and sit there for a second or two, then do My Pass.. this way I could see my ET if my 60ft were consistent. So if I am usually pulling 1.7 60 foots, but when I sit there and pull and 3.7 60 Ft I would just subtract 2.0 seconds from my Times..

But They didn't care about ET as much as MPH, because at 135+ MPH you need a full roll cage, Net Safety Gear ETC...

Does anyone know if they enforce any rules at the Roll Racing events that has become popular at the tracks?

 

I dont know the rules out by you, but I know in MI they will run 1/8th miles no ET events and the shut the lights off and you can run just about anything. Just a thought, maybe check and see if there's some events like that by you.

 

its always nice to get kicks off!!